Free shipping over $99 | Worldwide Delivery
Bitfala
Samsung Washer Door Lock DC34-00028A Main Image on White Background

Samsung Front Load Washer Door Lock Switch DC34-00028A DC34-00028B 120V Door Lock Assembly Replacement Part for Samsung Washers That Won't Open – DE Error Repair

Unit price:
In Stock - 1000 Units

Brief Description

Door lock switch assembly compatible with Samsung front load washers, corresponds to DC34-00028A (also fits DC34-00028B), 120V. Fixes door won't lock, DE error codes, and door stuck shut after the cycle.

Quantity

Fast Shipping
Secure Payment
30 Days Return

Product Overview

This is a replacement door lock switch assembly for Samsung front load washers, corresponding to OEM part number DC34-00028A (also compatible with DC34-00028B), rated at 120V. The door lock is a safety interlock on front load washers: the machine won't start unless the door is properly locked. When the latch bolt breaks or the contacts burn out, you get a door that won't lock, a DE error code, or a door that won't open after the wash — replacing this assembly fixes it.

Symptoms It Fixes (How to Tell the Door Lock Is Bad)

① Close the door and press Start — the door won't lock and the cycle won't begin; ② a DE / DC door fault code appears; ③ no "click" of the lock engaging, or it locks and immediately pops back open; ④ the door stays locked shut at the end of the cycle and won't open even after unplugging and waiting a few minutes. First check whether the door hook is bent; if the hook is fine and it still won't lock, the door lock assembly has failed.

Specifications

ItemSpecification
Corresponding Part NumbersDC34-00028A / DC34-00028B
Compatible BrandSamsung (front load models using the part numbers above)
Operating Voltage120V
TypeDoor lock / interlock switch assembly, plug-in terminals, original mounting holes
WeightApprox. 100g

Installation & Replacement Notes

Unplug the power cord, open the door, and use a flathead screwdriver to pry off the wire retaining ring on the outside of the large door seal. Fold the rubber lip inward to expose the door lock on the left side. Remove the 2 mounting screws, unplug the terminal connector, take out the old lock and fit the new one, then reassemble in reverse order. Takes about 20 minutes.

FAQ

Q: Is there any difference between DC34-00028A and 00028B?
A: They are alternate versions of the same design, with identical connectors and mounting points, and are interchangeable. Please check the part number printed on your old lock before ordering.

Q: The door locks, but I get a DE error halfway through the wash?
A: This is usually poor contact inside the lock — it holds the door but the signal cuts in and out, so the control board sees a door fault and stops the cycle. This intermittent behavior is typical of burned contacts; just replace the whole assembly.

Q: Is this an OEM part?
A: This is an aftermarket compatible replacement part, not manufactured by Samsung. The part numbers are for compatibility reference only; mounting holes and connector match the original.

Samsung washer door lock DC34-00028A assembly photo

Close-up of door lock switch connector and mounting clip