LG Front Load Washer Drain Pump 4681EA2001T 4681EA2001N 120V 80W Replacement for LG Kenmore Washers — Fixes No-Drain and OE Error
Brief Description
Drain pump replacement for LG and Kenmore washers, replaces part number 4681EA2001T. 120V 60Hz 80W, two-wire plug, mounting holes match the OEM layout. Solves no-drain issues, OE error codes and noisy draining.
Quantity
Product Overview
This drain pump is a replacement part for LG and Kenmore front-load and top-load washers, corresponding to OEM part number 4681EA2001T (also listed as 4681EA2001N and similar). 120V 60Hz 80W with a plug-and-play two-wire connector, and mounting holes that line up with the original — no rewiring or modification needed. When your washer won't drain, leaves standing water in the drum, or makes grinding noises while draining, the usual culprit is a seized impeller or a burned-out pump motor. Swapping in this pump is all it takes to get back to normal.
Compatible Symptoms (How to Tell the Drain Pump Has Failed)
① Water remains in the drum after the cycle ends and won't pump out; ② the display shows an OE / E1 drain fault code; ③ the pump hums or rattles during the drain stage but no water moves; ④ the washer retries the cycle repeatedly because water won't drain before the spin. If any of these apply, first clear any debris from the pump chamber — if that doesn't help, replace the drain pump.
Specifications
| Item | Specification |
|---|---|
| Replaces Part Numbers | 4681EA2001T / 4681EA2001N |
| Compatible Brands | LG, Kenmore (models using the part numbers above) |
| Voltage | 120V 60Hz |
| Power | 80W |
| Connector | Two-wire plug, pre-assembled pump housing |
| Construction | Corrosion-resistant impeller + seal ring, one-piece pump body |
Installation & Replacement Guide
Disconnect power and water, then remove the access panel at the bottom or the rear panel of the machine to locate the drain pump. Unscrew the 3 mounting screws, loosen the two hose clamps on the inlet and outlet hoses, pull the old pump and fit the new one, then reconnect the plug and tighten the clamps. About 15–20 minutes with a screwdriver and pliers — no rewiring required.
Frequently Asked Questions
Q: How do I confirm my washer uses the 4681EA2001T?
A: Check the part number on the label of the old pump, or look up your model on the LG official parts page. This pump fits all LG/Kenmore models that use 4681EA2001T.
Q: What if it still won't drain after replacing the pump?
A: First check that the drain hose isn't kinked or clogged, and that no coins, buttons or other debris are jamming the impeller in the pump chamber. Make sure the power plug is fully seated. If it still won't drain, the problem is likely the drain signal from the control board and needs separate diagnosis.
Q: Is this an OEM part?
A: This is an aftermarket compatible replacement part, not manufactured by LG/Kenmore. Brand and part numbers are referenced for compatibility only; mounting holes and connector match the original.


