Single Power Supply AC/DC Dual-Channel Speaker Protection Board, Power-On Delay, Power-Off Fast Disconnect, Anti-Shock, 4MM Fiberglass Board, Dual Relay, DC12-18V Power Supply, Speaker Amplifier Protection Module for Up to 300W
Brief Description
Dual-channel speaker protection board, delayed connection on power-on, fast disconnect on power-off, eliminates power-on shock noise, DC trigger voltage greater than 1.5V, DC12-18V AC or DC power supply, up to 300W.
Quantity
Product Introduction
This dual-channel speaker protection board is connected in series between the amplifier and the speaker: on power-on, it delays a few seconds before connecting the speaker, avoiding the amplifier's power-on shock; on power-off, it disconnects instantly, eliminating the power-off "pop" noise; it also features DC detection triggering (DC trigger voltage greater than 1.5V), cutting off immediately when a DC fault occurs in the amplifier output, protecting expensive speaker units. It uses a 4MM high-quality fiberglass board with tin-plated copper foil process.
Technical Specifications
| Item | Parameter |
|---|---|
| Channels | Dual-channel (two sets of independent relays) |
| Power Supply | AC or DC 12-18V (dual 12V-18V transformer windings) |
| DC Trigger Voltage | Greater than 1.5V |
| Applicable Power | Amplifiers up to 300W |
| Dimensions | 77×50mm |
Interface and Wiring Instructions
Three terminal groups on the board: connect to speaker (output to speaker), connect to amplifier (amplifier output input), AC/DC input (connect to transformer 12-18V winding or DC power supply). A slight sound when the relay engages is normal.
Frequently Asked Questions
Q: Is it normal for the speaker to sound a few seconds after power-on?
A: Yes, it is normal. This is the power-on delay protection, which connects the speaker only after the amplifier output is stable, avoiding shock noise and DC shock.
Q: Can it be used with high-power amplifiers like TDA7294?
A: Yes. It is suitable for power-on shock protection of common high-power amplifiers such as TDA7294, LM3886, LM1875, TDA7293, etc., and works with any up to 300W.
Q: How is the power supply connected?
A: Take AC power from the amplifier transformer's 12-18V winding, or connect to a DC power supply of the same voltage; the rectification and voltage regulation section on the board is already done.



