XH-A232 Digital Amplifier Board Dual Channel 30W Large Heatsink DC8-26V Wide Voltage Audio Amplifier Module DIY Speaker Sound Amplifier Board Speaker Amp Chip Accessories
Brief Description
XH-A232 digital amplifier board, dual-channel output, onboard large blue heatsink, DC8-26V wide voltage power supply, independent left and right channel output, DIY speaker amplification and modification accessory.
Quantity
Product Overview
The XH-A232 is a dual-channel digital amplifier board featuring a Class D digital amplification design, with a large blue aluminum heatsink onboard for stable performance during prolonged high-volume use. The board is compact (53×45mm) and supports DC8-26V wide voltage power input. It works directly with audio sources such as phones, MP3 players, and computer sound cards — ideal for DIY speakers, sound amplification modifications, and repair replacements.
Technical Specifications
| Item | Specification |
|---|---|
| Model | XH-A232 |
| Channels | Dual channel (stereo) |
| Output Power | Approx. 30W×2 (depends on supply voltage and speaker impedance) |
| Supply Voltage | DC 8-26V |
| Input | Standard 3.5mm/solder pad audio input L/R |
| Dimensions | 53×45mm, overall height 14mm |
Interfaces and Wiring Instructions
The board is labeled with left channel output, right channel output, audio input, and DC8-26V power input. All connection terminals are solder pads — simply solder according to the silkscreen markings for positive and negative polarity. Note: do not reverse the power polarity. Speaker impedance of 4-8Ω is recommended.
FAQ
Q: Can I use a 12V power supply?
A: Yes. It works with DC8-26V. The higher the supply voltage, the greater the output power — approximately 15W×2 at 12V, and up to 30W×2 at 24V.
Q: What speaker impedance can I connect?
A: 4-8Ω speakers are recommended. A 2Ω load draws excessive current and may trigger overcurrent protection during prolonged operation.
Q: What should I do about hum noise?
A: Use a linear power supply or increase the filter capacitance. Use shielded cable for input wiring and keep it away from the power transformer.



