Flow-type Ice Maker Microcomputer Universal Control Board Controller with Housing, Five-Channel Relay Output, Includes Ice Full/Water Level/Temperature/Ice Thickness Four Sensors, 1.5m Cable, One-Year Warranty, Accessories
Brief Description
Flow-type Ice Maker Microcomputer Controller (Type A with Housing), Fully Automatic Ice-Making Program, Five-Channel Relay Output, Includes Ice Full/Water Level/Temperature/Ice Thickness Four Sensors, 1.5m Cable, One-Year Warranty.
Quantity
Product Overview
This is a microcomputer controller (Type A, with mounting housing) for flow-type commercial ice makers, featuring a built-in fully automatic ice-making program: water filling → pre-cooling → ice making → ice harvesting → ice-full shutdown, all running automatically. Five-channel relay output, includes a full set of four sensors (ice-full switch, water level float, temperature probe, ice thickness probe), 1.5m cable, one-year warranty.
Operating Sequence (Fully Automatic)
1. Initial Power-On: The water level controller detects a low water level and opens the water inlet valve until high level is reached; at high level, it opens the hot gas valve to balance system pressure, otherwise it fills with water first.
2. Pre-Cooling: On first power-on, the compressor starts after a 30-second delay; the fan cycles automatically based on pipe temperature (starts at ≥27°C, stops at <26°C).
3. Ice Making: 30 seconds after the compressor starts, ice making begins — compressor on, water pump on, fan cycling based on pipe temperature, hot gas valve closed.
4. Ice Harvesting: After 5 minutes of ice making, the ice thickness switch is checked; if the ice is thick enough or ice making exceeds 40 minutes, ice harvesting begins — compressor on, water pump off, hot gas valve open, fan off. When the harvest-end switch opens and then resets, ice harvesting ends and the next ice-making cycle begins.
5. Ice-Full Shutdown: If the harvest-end switch remains open for more than 30 seconds, the ice bin is judged full and the unit enters shutdown until the ice is emptied and it restarts for the next cycle.
Outputs & Configuration
| Item | Description |
|---|---|
| Five-channel relay output | Fan / Water inlet valve / Water pump / Hot gas valve / Compressor |
| Sensor inputs | Ice-full switch, water level float, temperature probe (condenser pipe temperature), ice thickness probe |
| Included accessories | Full set of four sensors, 1.5m cable |
| Onboard indicators | Normal ice making, ice full, ice harvesting, water level indicator lights |
| Warranty | One year |
FAQ
Q: What accessories are included with this control board?
A: The main board comes with a mounting housing and includes four sensors: ice-full switch, water level float, temperature probe, and ice thickness probe, all with 1.5m cables. Just connect and it's ready for setup.
Q: What causes incomplete ice harvesting?
A: Ice harvesting relies on the hot gas valve heating the evaporator. First check whether the hot gas valve output is activating and whether the valve is worn out; then confirm the ice thickness probe is positioned correctly, as an overly thick ice bridge can make harvesting difficult.
Q: How long is the warranty?
A: This board comes with a one-year warranty. Non-human-caused damage (excluding water damage, incorrect external voltage, or unauthorized modification) is eligible for free replacement.

