Free shipping over $99 | Worldwide Delivery
Bitfala
Ice Maker Ice Thickness Sensor Flow-Type Single-Wire Probe, Ice Full Detection Thickness Switch, CKY Ice Bridge Adjustment Probe Fitting, 1.5m Cable

Ice Thickness Sensor for Ice Makers, Flow-Type Single-Wire Probe, Ice Bridge Thickness Detection Switch, CKY Ice Bridge Adjustment Screw, 1.5m Cable, Adjustable Fitting for Ice Too Thin, Too Thick, or Not Releasing

Unit price:
In Stock - 1000 Units

Brief Description

Flow-type ice maker single-wire ice thickness sensor probe, stainless steel T-shaped sensing plate, red single wire with spade terminal, cable length approx. 1.5m, with CKY ice bridge thickness adjustment screw, triggers ice release when the ice layer reaches the set thickness. Compatible with all kinds of flow-type ice cube machines, solves problems such as failure to release ice, ice too thin or too thick. This page includes dimensions and adjustment instructions.

Quantity

Fast Shipping
Secure Payment
30 Days Return

Product Overview

This probe is a single-wire ice thickness sensor designed for flow-type ice makers. It is installed above the ice lane on the evaporator and detects ice layer thickness via a stainless steel T-shaped sensing plate: once the ice reaches the set thickness, it outputs a signal and the control board immediately enters the ice release cycle. The bracket features a CKY ice bridge thickness adjustment screw (INCREASE ICE BRIDGE), allowing you to adjust the ice bridge thickness as needed.

Ice maker single-wire ice thickness sensor CKY

Technical Parameters

ItemParameter
TypeIce thickness detection sensor (single-wire output)
Sensing plateStainless steel T-shaped sensing plate
Output wireRed single wire + blue spade terminal
Cable lengthApprox. 1.5 m
Adjustment functionCKY screw adjusts ice bridge thickness (INCREASE ICE BRIDGE)
Bracket dimensionsApprox. 83mm × 55mm (see dimension drawing)

Ice thickness sensor dimensions 83/55/43/78/58mm, cable length 1.5M

Working Principle and Adjustment

During ice making, water flows through the ice lane and the ice layer gradually thickens; when the ice surface touches the T-shaped sensing plate and forms an ice bridge, the sensor outputs a signal and the control board stops ice making and enters ice release. Turning the adjustment screw clockwise increases the ice bridge thickness, while turning it the opposite way reduces it; when the ice is too thin and breaks easily or too thick and hard to release, simply fine-tune with this screw.

Rear installation view of the ice thickness sensor

Close-up of the T-shaped sensing plate and adjustment screw

Replacement Tips

  • Cut off power and water before replacement
  • Reinstall the bracket in its original position; the sensing plate must not touch the ice lane wall
  • Insert the spade terminal firmly to avoid poor contact causing failure to release ice
  • After installation, run a full ice-making cycle to check, and fine-tune the ice bridge thickness if necessary

FAQ

Q: What is the ice thickness sensor used for?

A: It detects the ice layer thickness in the ice lane and signals the control board to trigger ice release once the thickness is reached. It is a key sensing component of flow-type ice makers.

Q: How do I adjust if the ice is too thin or too thick?

A: The bracket has a CKY adjustment screw (INCREASE ICE BRIDGE); turning the screw increases or decreases the ice bridge thickness.

Q: How long is the cable? How do I connect it?

A: The red single wire is about 1.5 m long, with a blue spade terminal at the end; simply plug it into the corresponding terminal on the control board.

Q: When does it need to be replaced?

A: When ice fails to release, the machine does not stop at full ice, or ice thickness is abnormal and adjustment has no effect, the sensor is usually faulty and should be replaced.